Table of Contents
Advertisement
Multicast group policy does not work
Symptom
Hosts can receive multicast data for multicast groups that are not permitted by the multicast group
policy.
Solution
To resolve the problem:
1.
Use the display acl command to verify that the configured ACL meets the multicast group
policy requirements.
2.
Use the display this command in IGMP-snooping view or in a corresponding interface view to
verify that the correct multicast group policy has been applied. If the applied policy is not correct,
use the group-policy or igmp-snooping group-policy command to apply the correct
multicast group policy.
3.
Use the display igmp-snooping command to verify that dropping unknown multicast data is
enabled. If it is not, use the igmp-snooping drop-unknown command to enable dropping
unknown multicast data.
4.
If the problem persists, contact Hewlett Packard Enterprise Support.
55
Advertisement
Table of Contents
Troubleshooting
