Configuring Static Ports - HP FlexFabric 5950 series Configuration Manual

setting the MLD last listener query interval on the Layer 2 device, see "Setting the MLD last
listener query interval."
•
You can set the timers globally for all VLANs and VSIs in MLD-snooping view, for a VSI in VSI
view, or for a VLAN in VLAN view. For a VSI, the VSI-specific configuration takes priority over
the global configuration. For a VLAN, the VLAN-specific configuration takes priority over the
global configuration.
Setting the aging timers for dynamic ports globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Set the aging timer for
dynamic router ports
globally.
4. Set the aging timer for
dynamic member ports
globally.
Setting the aging timers for dynamic ports in a VLAN or VSI
Step
1. Enter system view.
2. Enter VLAN view or VSI view.
3. Set the aging timer for
dynamic router ports in the
VLAN or VSI.
4. Set the aging timer for
dynamic member ports in the
VLAN or VSI.

Configuring static ports

You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for an IPv6 multicast
group, all hosts attached to the port will receive IPv6 multicast data for the group.
The static member port does not respond to MLD queries. When you complete or cancel this
configuration, the port does not send an unsolicited report or done message.
•
Static router port—When you configure a port as a static router port for an IPv6 multicast
group, all IPv6 multicast data for the group received on the port will be forwarded.
To configure a port as a static port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the port as a static
Command
system-view
mld-snooping
router-aging-time seconds
host-aging-time seconds
Command
system-view
•
Enter VLAN view:
vlan vlan-id
•
Enter VSI view:
vsi vsi-name
mld-snooping
router-aging-time seconds
mld-snooping
host-aging-time seconds
Command
system-view
interface interface-type interface-
number
•
Configure the port as a static
295
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A
N/A
By default, a port is not a static