Table of Contents
Advertisement
HGE1/0/2
Downstream ports (1 in total):
HGE1/0/4
Expires: 00:03:01, FSM: J
The output shows the following information:
•
Switch A will forward the multicast data intended for IPv6 multicast group FF1E::101 to only
Router C.
•
Switch A will forward the multicast data intended for IPv6 multicast group FF2E::101 to only
Router D.
Troubleshooting IPv6 PIM snooping
This section describes common IPv6 PIM snooping problems and how to troubleshoot them.
IPv6 PIM snooping does not work on a Layer 2 device
Symptom
IPv6 PIM snooping does not work on a Layer 2 device.
Solution
To resolve the problem:
1.
Use the display current-configuration command to display information about MLD snooping
and IPv6 PIM snooping.
2.
If MLD snooping is not enabled, enable MLD snooping globally, and then enable MLD snooping
and IPv6 PIM snooping for the VLAN or VSI.
3.
If IPv6 PIM snooping is not enabled, enable IPv6 PIM snooping for the VLAN or VSI.
4.
If the problem persists, contact Hewlett Packard Enterprise Support.
334
Advertisement
Table of Contents
Troubleshooting
