Enabling Basic Qinq; Configuring Selective Qinq (Available Only On The A3100 V2; Configuring An Outer Vlan Tagging Policy In The Port-Based Approach - HP A3100-8 v2 SI Configuration Manual

NOTE:
QinQ requires configurations only on the service provider network.
•
QinQ configurations made in Ethernet interface view take effect on the current interface only. Those
•
made in Layer 2 aggregate interface view take effect on the current aggregate interface and all the
member ports in the aggregation group. Those made in port group view take effect on all member ports
in the current port group.

Enabling basic QinQ

A basic QinQ-enabled port tags an incoming packet with its PVID.
Follow these steps to enable basic QinQ:
To do...
Enter system view
Enter interface
view or port
group view
Enable basic QinQ
Configuring selective QinQ (available only on the
A3100 v2 EI)
Basic QinQ can only tag received frames with the PVID of the receiving port. Selective QinQ allows
adding different outer VLAN tags based on different inner VLAN tags.
You can configure an outer VLAN tagging policy in one of the following approaches:
• Port-based approach
QoS policy-based approach
•
Configuring an outer VLAN tagging policy in the port-based
approach
Follow these steps to configure an outer VLAN tagging policy in the port-based approach:
To do...
Enter system view
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view
Enter port group view
Use the command...
system-view
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
qinq enable
140
Remarks
—
Required
Use either command.
Required
Disabled by default.
Remarks
—