HP FlexFabric 5950 series Configuration Manual page 176

•
The entire PIM domain operates in the SSM mode.
•
Host A and Host C are multicast receivers on two stub networks.
•
The SSM group range is 232.1.1.0/24.
•
IGMPv3 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 59 Network diagram
Source
10.110.5.100/24
Table 13 Interface and IP address assignment
Device
Switch A
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
1. Assign an IP address and subnet mask to each interface, as shown in
shown.)
2. Configure OSPF on the switches in the PIM-SSM domain. (Details not shown.)
3. Enable IP multicast routing, IGMP, and PIM-SM:
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
Vlan-int300 Vlan-int105
Vlan-int105
Switch D Switch E
PIM-SSM
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Vlan-int200 10.110.2.1/24
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch B
Vlan-int104
Vlan-int200
Switch C
Device
Switch D
Switch D
Switch D
Switch E
Switch E
Switch E
Switch E
166
Receiver
Host A
Host B
Receiver
Vlan-int200
Host C
Host D
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24
Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.2/24
Vlan-int102 192.168.9.2/24
Vlan-int105 192.168.4.1/24
Figure 59. (Details not