AudioCodes Mediant 800B User Manual page 845

User's Manual
Parameter
NAT Translation Table
Web: NAT Translation
Table
CLI: configure voip > voip-
network NATTranslation
[NATTranslation]
Media Realm Table
Web: Media Realm Table
EMS: Media Realm
CLI: configure voip > voip-
network realm
[CpMediaRealm]
Remote Media Subnet Table
Web: Remote Media
Subnet
EMS: Remote Media
Subnet
CLI: configure voip > voip-
network realm
remotemediasubnet
[SubRealm]
Version 6.8
This table parameter defines NAT rules for translating source IP
addresses per VoIP interface (SIP control and RTP media traffic) into
NAT IP addresses. This allows, for example, the separation of VoIP
traffic between different ISTP's, and topology hiding (of internal IP
addresses to the "public" network). Each IP interface (configured in the
Interface table - InterfaceTable parameter) can be associated with a NAT
rule in this table, translating the source IP address and port of the
outgoing packet into the NAT address (IP address and port range).
The format of the ini file table parameter is as follows:
[ NATTranslation ]
FORMAT NATTranslation_Index =
NATTranslation_SourceIPInterfaceName,
NATTranslation_TargetIPAddress, NATTranslation_SourceStartPort,
NATTranslation_SourceEndPort, NATTranslation_TargetStartPort,
NATTranslation_TargetEndPort;
[ \NATTranslation ]
For a detailed description of this table, see ''Configuring NAT Translation
per IP Interface'' on page 143.
This table parameter defines Media Realms. The Media Realm table
allows you to divide a Media-type interface (defined in the Interface
table) into several realms, where each realm is specified by a UDP port
range.
The format of the ini file table parameter is as follows:
[ CpMediaRealm ]
FORMAT CpMediaRealm_Index = CpMediaRealm_MediaRealmName,
CpMediaRealm_IPv4IF, CpMediaRealm_IPv6IF,
CpMediaRealm_PortRangeStart, CpMediaRealm_MediaSessionLeg,
CpMediaRealm_PortRangeEnd, CpMediaRealm_IsDefault,
CpMediaRealm_QoeProfile, CpMediaRealm_BWProfile;
[ \CpMediaRealm ]
For a detailed description of this table, see ''Configuring Media Realms''
on page 265.
This table parameter defines Remote Media Subnets.
The format of the ini file table parameter is as follows:
[RemoteMediaSubnet]
FORMAT RemoteMediaSubnet_Index = RemoteMediaSubnet_Realm,
RemoteMediaSubnet_RemoteMediaSubnetIndex,
RemoteMediaSubnet_RemoteMediaSubnetName,
RemoteMediaSubnet_PrefixLength,
RemoteMediaSubnet_AddressFamily,
RemoteMediaSubnet_DstIPAddress,
RemoteMediaSubnet_QOEProfileName,
RemoteMediaSubnet_BWProfileName;
[\RemoteMediaSubnet]
For a detailed description of this table, see ''Configuring Remote Media
Subnets'' on page 269.
845
57. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC