AudioCodes Mediant 800B User Manual page 667

User's Manual
9. If you want to load additional files, skip this step and continue with the next step. If you
only want to load a .cmp file, click Reset
flash memory and then resets. The device uses the existing configuration (ini) and
auxiliary files.
Note:
cmp file version.
10. To load additional files, use the Next
the wizard to the desired file-load wizard page. Alternatively, you can navigate to the
relevant file-load wizard page by clicking the respective file-name buttons listed in the
left pane of the wizard pages.
11. The wizard page for loading an ini file provides you with the following options:
•
Load a new ini file: In the 'Load an ini file...' field, click Browse, and then
navigate to where the ini file is located on your computer. Select the file, and then
click Load File; the device loads the ini file.
Note:
assigned default values (according to the .cmp file running on the device) and
thereby, overwrite values previously configured for these parameters.
•
Retain the existing configuration (default): Select the 'Use existing
configuration' check box to use the current configuration (and do not select an ini
file).
•
Restore configuration to factory defaults: Clear the 'Use existing configuration'
check box (and do not select an ini file).
Version 6.8
Device reset may take a few minutes (even up to 30 minutes) depending on
If you use the wizard to load an ini file, parameters excluded from the ini file are
Figure 41-8: Software Upgrade Wizard – Load INI File
; the device burns the .cmp file to its
and Back
667 Mediant 800B Gateway and E-SBC
41. Software Upgrade
buttons to navigate through