AudioCodes Mediant 800B User Manual page 591

User's Manual
Parameter
CLI: calling-name-prefix
[IPOutboundManipulation_CallingNam
ePrefix]
Message Condition
CLI: message-condition
[IPOutboundManipulation_MessageCo
ndition]
Request Type
CLI: request-type
[IPOutboundManipulation_RequestTyp
e]
ReRoute IP Group ID
CLI: re-route-ip-group-id
[IPOutboundManipulation_ReRouteIP
GroupID]
Call Trigger
CLI: trigger
[IPOutboundManipulation_Trigger]
Version 6.8
calling name appears in the SIP From header.
The valid value is a string of up to 37 characters. By
default, no prefix is defined.
Assigns a Message Condition rule as a matching
characteristic. Message Condition rules define required
SIP message formats. For configuring Message Condition
rules, see ''Configuring Message Condition Rules'' on
page 570.
Defines the SIP request type to which the manipulation
rule is applied.

[0] All = (Default) all SIP messages.

[1] INVITE = All SIP messages except REGISTER
and SUBSCRIBE.

[2] REGISTER = Only SIP REGISTER messages.

[3] SUBSCRIBE = Only SIP SUBSCRIBE messages.

[4] INVITE and REGISTER = All SIP messages
except SUBSCRIBE.

[5] INVITE and SUBSCRIBE = All SIP messages
except REGISTER.
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This parameter
is typically used for re-routing requests (e.g., INVITEs)
when interworking is required for SIP 3xx redirect
responses or REFER messages.
The default is -1 (i.e., not configured).
Notes:

This parameter functions together with the 'Call
Trigger' parameter (see below).

For more information on interworking of SIP 3xx
redirect responses or REFER messages, see
''Interworking SIP 3xx Redirect Responses'' on page
540 and ''Interworking SIP REFER Messages'' on
page 543, respectively.
Defines the reason (i.e, trigger) for the re-routing of the
SIP request:

[0] Any = (Default) Re-routed for all scenarios (re-
routes and non-re-routes).

[1] 3xx = Re-routed if it triggered as a result of a SIP
3xx response.

[2] REFER = Re-routed if it triggered as a result of a
REFER request.

[3] 3xx or REFER = Applies to options [1] and [2].

[4] Initial only = Regular requests that the device
forwards to a destination. In other words, re-routing of
requests triggered by the receipt of REFER or 3xx
does not apply.
591
29. SBC Configuration
Description
Mediant 800B Gateway and E-SBC