One-Stage Dialing - AudioCodes Mediant 800B User Manual

User's Manual
27.13.1.1

One-Stage Dialing

One-stage dialing is when the FXO device receives an IP-to-Tel call, off-hooks the PBX
line connected to the telephone, and then immediately dials the destination telephone
number. In other words, the IP caller doesn't dial the PSTN number upon hearing a dial
tone.
One-stage dialing incorporates the following FXO functionality:

Waiting for Dial Tone: Enables the device to dial the digits to the Tel side only after
detecting a dial tone from the PBX line. The ini file parameter IsWaitForDialTone is
used to configure this operation.

Time to Wait Before Dialing: Defines the time (in msec) between seizing the FXO
line and starting to dial the digits. The ini file parameter WaitForDialTime is used to
configure this operation.
Note:

Answer Supervision: The Answer Supervision feature enables the FXO device to
determine when a call is connected, by using one of the following methods:
•
Polarity Reversal: the device sends a 200 OK in response to an INVITE only
when it detects a polarity reversal.
•
Voice Detection: the device sends a 200 OK in response to an INVITE only
when it detects the start of speech (fax or modem answer tone) from the Tel side.
Note that the IPM detectors must be enabled.
Version 6.8
The ini file parameter IsWaitForDialTone must be disabled for this mode.
507 Mediant 800B Gateway and E-SBC
27. Analog Gateway