Configuring Web Operations To Report To Syslog; Configuring Debug Recording - AudioCodes Mediant 800B User Manual

User's Manual
51.3

Configuring Web Operations to Report to Syslog

You can define the operations (activities) in the Web interface that must be reported to the
Syslog server. The following procedure describes how to configure this in the Web
interface. You can also configure this using the ini file parameter, ActivityListToLog or CLI
command, config-system > logging > activity-log.

To define Web activities to report to Syslog server:
1. Open the Syslog Settings page (Configuration tab > System menu > Syslog
Settings).
2. Under the Activity Types to Report via Activity Log Messages group, select the Web
actions to report to the Syslog server. For more information, see ''Syslog, CDR and
Debug Parameters'' on page 812.
3. Click Submit.
51.4

Configuring Debug Recording

The device enables you to activate debug recording and send debug recording packets to
a defined capturing server. When the debug recording is activated, the device duplicates all
messages that are sent and/or received by it and then sends them to an external IP
address. The debug recording can be done for different types of traffic for example,
RTP/RTCP, T.38, ISDN, CAS, and SIP.
Debug recording is used for advanced debugging when you need to analyze internal
messages and signals. Debug recording is also useful for recording network traffic in
environments where hub or port mirroring is unavailable and for recording internal traffic
between two endpoints on the same device.
Notes:
•
Debug recording is collected only on the device's OAMP interface.
•
You can also save debug recordings to an external USB hard drive that is
connected to the device's USB port. For more information, see USB Storage
Capabilities on page 691.
Version 6.8
Figure 51-2: Web Activities to Report to Syslog
51. Syslog and Debug Recordings
753 Mediant 800B Gateway and E-SBC