AudioCodes Mediant 800B User Manual page 400

Parameter
Source IP Group ID
CLI: src-ip-group-id
[_SrcIPGroupID]
Web/EMS: Source IP
Address
CLI: src-ip-address
[_SourceAddress]
Web: Source Host Prefix
CLI: src-host-prefix
[_SrcHost]
Web: Destination Host Prefix
CLI: dst-host-prefix
[_DestHost]
Operation (Action)
Web: Stripped Digits From
Left
EMS: Remove From Left
CLI: remove-from-left
[_RemoveFromLeft]
Web: Stripped Digits From
Right
EMS: Remove From Right
CLI: remove-from-right
[_RemoveFromRight]
User's Manual
Defines the IP Group from where the IP call originated. Typically, the
IP Group of an incoming INVITE is determined or classified by the
Inbound IP Routing table.
If not used (i.e., any IP Group), leave the field empty. The value -1
indicates that it is ignored in the rule.
Notes:

This parameter is applicable only to the Redirect Number Tel > IP
table.

This parameter is applicable only to the IP-to-IP application.
Defines the IP address of the caller. The IP address appears in the
SIP Contact header of the incoming INVITE message.
The default value is the asterisk (*) symbol (i.e., any IP address). The
value can include the following wildcards:

"x": represents single digits, for example, 10.8.8.xx denotes all
addresses between 10.8.8.10 and 10.8.8.99.

"*": represents any number between 0 and 255, for example,
10.8.8.* denotes all addresses between 10.8.8.0 and 10.8.8.255.
Note: This parameter is applicable only to the Redirect Number IP-to-
Tel table.
Defines the URI host name prefix of the caller. The host name
appears in the SIP From header of the incoming SIP INVITE
message.
The default value is the asterisk (*) symbol (i.e., any host name
prefix).
Notes:

This parameter is applicable only to the Redirect Number IP-to-Tel
table.

If the P-Asserted-Identity header is present in the incoming INVITE
message, then the value of this parameter is compared to the P-
Asserted-Identity URI host name (instead of to the From header).
Defines the Request-URI host name prefix, which appears in the
incoming SIP INVITE message.
The default value is the asterisk (*) symbol (i.e., any prefix).
Note: This parameter is applicable only to the Redirect Number IP-to-
Tel table.
Defines the number of digits to remove from the left of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 1234.
Defines the number of digits to remove from the right of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 5551.
400
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10620