AudioCodes Mediant 800B User Manual page 971

User's Manual
Parameter
EMS: Enable CIC
[EnableCIC]
Web/EMS: AoC Support
[EnableAOC]
Web: IPMedia Detectors
EMS: DSP Detectors Enable
CLI: IPM-detectors-enable
[EnableDSPIPMDetectors]
Web: Add IE in SETUP
EMS: IE To Be Added In Q.931
Setup
CLI: add-ie-in-setup
[AddIEinSetup]
Web: Trunk Groups to Send IE
EMS: List Of Trunk Groups To
Send IE
CLI: trkgrps-to-snd-ie
[SendIEonTG]
Web: Enable User-to-User IE
for Tel to IP
Version 6.8
Determines whether the Carrier Identification Code (CIC) is relayed
to ISDN.

[0] = (Default) Do not relay the Carrier Identification Code (CIC)
to ISDN.

[1] = CIC is relayed to the ISDN in Transit Network Selection
(TNS) IE.
If enabled, the CIC code (received in an INVITE Request-URI) is
included in a TNS IE in the ISDN Setup message.
For example: INVITE sip:555666;cic=2345@100.2.3.4 sip/2.0.
Notes:

This feature is supported only for SIP-to-ISDN calls.

The parameter AddCicAsPrefix can be used to add the CIC as a
prefix to the destination phone number for routing IP-to-Tel calls.
Enables the interworking of ISDN Advice of Charge (AOC)
messages to SIP.

[0] Disable (default)

[1] Enable
For more information on AOC, see ''Advice of Charge Services for
Euro ISDN'' on page 485.
Enables the device's DSP detectors.

[0] = Disable (default)

[1] = Enable
Notes:

For this parameter to take effect, a device reset is required.

The DSP Detectors feature is available only if the device is
installed with a Software License Key that includes this feature.
For installing a Software License Key, see ''Software License
Key'' on page 661.

When enabled (1), the number of available channels is reduced.
Global parameter that defines an optional Information Element (IE)
data (in hex format) to add to ISDN Setup messages. You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_AddIEInSetup). For a detailed description of this
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 323.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is sent.
For example: '1,2,4,10,12,6'.
Notes:

You can configure different IE data for Trunk Groups by defining
this parameter for different IP Profile IDs (using the parameter
IPProfile), and then assigning the required IP Profile ID in the
Inbound IP Routing table (PSTNPrefix).

When IP Profiles are used for configuring different IE data for
Trunk Groups, this parameter is ignored.
Enables transfer of User-to-User (UU) IE from ISDN PRI to SIP.
971
57. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC