AudioCodes Mediant 800B User Manual page 941

User's Manual
Parameter
[ProtocolType_x]
[ISDNTimerT310]
Version 6.8
Lucent™/AT&T™ 5ESS-10 switch.

[14] T1 DMS100 ISDN = ISDN PRI protocol for the Nortel™
DMS switch.

[15] J1 TRANSPARENT

[16] T1 NTT ISDN = ISDN PRI protocol for the Japan - Nippon
Telegraph Telephone (known also as INS 1500).

[17] E1 AUSTEL ISDN = ISDN PRI protocol for the Australian
Telecom.

[18] E1 HKT ISDN = ISDN PRI (E1) protocol for the Hong Kong
- HKT.

[19] E1 KOR ISDN = ISDN PRI protocol for Korean Operator
(similar to ETSI).

[20] T1 HKT ISDN = ISDN PRI (T1) protocol for the Hong Kong
- HKT.

[21] E1 QSIG = ECMA 143 QSIG over E1

[22] E1 TNZ = ISDN PRI protocol for Telecom New Zealand
(similar to ETSI)

[23] T1 QSIG = ECMA 143 QSIG over T1

[30] E1 FRENCH VN6 ISDN = France Telecom VN6

[31] E1 FRENCH VN3 ISDN = France Telecom VN3

[34] T1 EURO ISDN =ISDN PRI protocol for Euro over T1

[35] T1 DMS100 Meridian ISDN = ISDN PRI protocol for the
Nortel™ DMS Meridian switch

[36] T1 NI1 ISDN = National ISDN 1 PRI protocol

[40] E1 NI2 ISDN = National ISDN 2 PRI protocol over E1

[50] BRI EURO ISDN = Euro ISDN over BRI

[51] BRI NI2 ISDN

[52] BRI DMS 100 ISDN

[53] BRI 5ESS 10 ISDN

[54] BRI QSIG = QSIG over BRI

[55] BRI VN6 = VN6 over BRI

[56] BRI NTT = BRI ISDN Japan (Nippon Telegraph)

[57] BRI IUA
Notes:

All PRI trunks must be configured as the same line type (either
E1 or T1). The device can support different variants of CAS and
PRI protocols on different E1/T1 spans (no more than four
simultaneous PRI variants).

BRI trunks can operate together with E1 or T1 trunks.

The ISDN BRI North American variants (NI-2, DMS-100, and
5ESS) are partially supported by the device. Please contact
your AudioCodes sales representative before implementing this
protocol.
Defines the protocol type for a specific trunk ID (where x denotes
the Trunk ID and 0 is the first trunk). For more information, see the
ProtocolType parameter.
Defines the T310 override timer for DMS, Euro ISDN, and ISDN NI-
2 variants. An ISDN timer is started when a Q.931 Call Proceeding
message is received. The timer is stopped when a Q.931 Alerting,
Connect, or Disconnect message is received from the other end. If
no ISDN Alerting, Progress, or Connect message is received within
941
57. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC