Call Transfer Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
CLI: dis-reminder-ring
[DisableReminderRing]
CLI: dtmf-during-hold
[PlayDTMFduringHold]
57.10.5.6

Call Transfer Parameters

The call transfer parameters are described in the table below.
Parameter
Web/EMS: Enable Transfer
CLI: enable-transfer
[EnableTransfer]
Version 6.8

This parameter is applicable only to FXS interfaces.

This Reminder Ring feature can be disabled using the
DisableReminderRing parameter.
Disables the reminder ring, which notifies the FXS user of a call on hold
or a waiting call when the phone is returned to on-hook position.

[0] = (Default) The reminder ring feature is active. In other words, if a
call is on hold or there is a call waiting and the phone is changed from
offhook to onhook, the phone rings (for a duration defined by the
CHRRTimeout parameter) to "remind" you of the call hold or call
waiting.

[1] = Disables the reminder ring. If a call is on hold or there is a call
waiting and the phone is changed from offhook to onhook, the call is
released (and the device sends a SIP BYE to the IP).
Notes:

This parameter is applicable only to FXS interfaces.

This parameter is typically used for MLPP, allowing preemption to
clear held calls.
Determines whether the device sends DTMF signals (or DTMF SIP INFO
message) when a call is on hold.

[0] = (Default) Disable.

[1] = Enable - If the call is on hold, the device stops playing the Held
tone (if it is played) and sends DTMF:

To Tel side: plays DTMF digits according to the received SIP
INFO message(s). (The stopped held tone is not played again.)

To IP side: sends DTMF SIP INFO messages to an IP destination
if it detects DTMF digits from the Tel side.
Table 57-47: Call Transfer Parameters
Enables the Call Transfer feature.

[0] Disable

[1] Enable = (Default) The device responds to a REFER
message with the Referred-To header to initiate a call
transfer. For analog interfaces: If the transfer service is
enabled, the user can activate Transfer using hook-flash
signaling. If this service is enabled, the remote party
performs the call transfer.
Notes:

To use call transfer, the devices at both ends must support
this option.

To use call transfer, set the parameter EnableHold to 1.
923
57. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway and E-SBC