Open Solution Network (Osn) Parameters; Quality Of Service Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Static Route Table
Web/EMS: Static Route
Table
CLI: configure voip > static
[StaticRouteTable]

57.2.4 Open Solution Network (OSN) Parameters

The OSN server parameters are described in the table below.
Parameter
Web: OSN Native VLAN
ID
CLI: configure system >
interface osn > native-vlan
<id>
[OSNAccessVlan]
Web: Block OSN Port
CLI: configure system >
interface osn > shutdown
[OSNBlockPort]

57.2.5 Quality of Service Parameters

The Quality of Service (QoS) parameters are described in the table below.
Parameter
Layer-2 Class Of Service (CoS) Parameters (VLAN Tag Priority Field)
Web: DiffServ Table
EMS: QoS Settings –
DSCP to QoS Mapping
CLI: configure voip >
vlan-mapping
[DiffServToVlanPriority]
Version 6.8
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
For a description of this parameter, see ''Configuring Static IP Routes''
on page 130.
Table 57-12: OSN Parameters
Defines the OSN Native VLAN ID.
The valid value is 0 to 4000. When set to 0 (default), the OSN uses the
device's OAMP VLAN ID. When set to any other value, it specifies a
VLAN ID configured in the Ethernet Device table and which is assigned
to a Media and/or Control application in the Interface table.
Enables or disables the Ethernet port of the internal switch that
interfaces with the OSN.

[0] Enable (default)

[1] Disable
Table 57-13: QoS Parameters
This table parameter configures DiffServ-to-VLAN Priority mapping. For
each packet sent to the LAN, the VLAN Priority of the packet is set
according to the DiffServ value in the IP header of the packet.
The format of this ini file is as follows:
[ DiffServToVlanPriority ]
FORMAT DiffServToVlanPriority_Index = DiffServToVlanPriority_DiffServ,
DiffServToVlanPriority_VlanPriority;
[ \DiffServToVlanPriority ]
For example:
DiffServToVlanPriority 0 = 46, 6;
DiffServToVlanPriority 1 = 40, 6;
DiffServToVlanPriority 2 = 26, 4;
801
57. Configuration Parameters Reference
Description
Description
Description
Mediant 800B Gateway and E-SBC