Configuring Maximum Telnet/Ssh Sessions - AudioCodes Mediant 800B User Manual

The following procedure describes how to access the CLI through Telnet/SSH.
Note: The CLI login credentials are the same as all the device's other management
interfaces (such as Web interface). The default username and password is "Admin"
and "Admin" (case-sensitive), respectively. For configuring login credentials, see
''Configuring Web User Accounts'' on page 59.

To establish a CLI session with the device:
1. Connect the device to the network.
2. Establish a Telnet or SSH session using the device's OAMP IP address.
3. Log in to the session using the username and password assigned to the Admin user of
the Web interface:
a. At the Username prompt, type the username, and then press Enter:
Username: Admin
b. At the Password prompt, type the password, and then press Enter:
Password: Admin
c. At the prompt, type the following, and then press Enter:
> enable
d. At the prompt, type the password again, and then press Enter:
Password: Admin
7.4

Configuring Maximum Telnet/SSH Sessions

You can set the maximum (up to five) number of concurrent Telnet/SSH sessions permitted
on the device.
Note: Before changing this setting, make sure that not more than this number of
sessions are currently active; otherwise, the new setting will not take effect.

To configure the maximum number of concurrent Telnet/SSH sessions:
1. Open the Telnet/SSH Settings page (Configuration tab > System menu >
Management > Telnet/SSH Settings).
2. In the 'Maximum Telnet Sessions' field, enter the maximum number of concurrent
sessions.
3. Click Submit.
User's Manual
Mediant 800B Gateway and E-SBC
78 Document #: LTRT-10620