AudioCodes Mediant 800B User Manual page 589

User's Manual

Operation (Action) - if the incoming call matches the characteristics of the rule, the
device manipulates the source or destination SIP URI user part or calling name of the
SIP dialog (e.g., removes user-defined number of characters from the left of the SIP
URI user part).
Note:
configured in the IP Group table. These manipulations are simply host name
substitutions with the names configured for the source and destination IP Groups,
respectively.
The following procedure describes how to configure IP-to-IP Outbound Manipulation rules
in the Web interface. You can also configure these rules using the table ini file parameter,
IPOutboundManipulation or CLI command, configure voip > sbc manipulations ip-
outbound-manipulation.

To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click Add; the following dialog box appears:
Figure 29-13: IP to IP Outbound Manipulation Page
3. Configure an IP-to-IP outbound manipulation rule according to the parameters
described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Version 6.8
SIP URI host name (source and destination) manipulations can also be
- Add Dialog Box
589 Mediant 800B Gateway and E-SBC
29. SBC Configuration