AudioCodes Mediant 800B User Manual page 483

User's Manual
The following procedure describes how to configure the Supplementary Services table in
the Web interface. You can also configure this table using the table ini file parameter,
ISDNSuppServ or CLI command, configure voip > gw digitalgw isdn-supp-serv.

To configure endpoint supplementary services:
1. Open the Supplementary Services Table page (Configuration tab > VoIP menu >
GW and IP to IP > DTMF and Supplementary > Supp Services Table).
2. Click Add; the following dialog box appears:
Figure 26-10: Supplementary Services Table - Add Record
3. Configure a supplementary service according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
The figure below displays an example of multiple-line extensions configured in the
Supplementary Services table:
You can register and un-register an endpoint configured in the table. The registration
method is according to the 'Registration Mode' parameter located in the Trunk Group
Settings page (see ''Configuring Hunt Group Settings'' on page 381).

To register or un-register an endpoint:
1. Select the required table row in which the endpoint is configured.
2. From the 'Action' drop-down list, select Register. To unregister the endpoint, select
Un-Register.
Table 26-9: Supplementary Services Table Parameter Description
Parameter
Index
[ISDNSuppServ_Index]
Version 6.8
Figure 26-11: Supplementary Services Table Page
Defines an index number for the new table record.
26. Configuring Supplementary Services
Description
483 Mediant 800B Gateway and E-SBC