Networking Parameters; Ethernet Parameters - AudioCodes Mediant 800B User Manual

User's Manual
57.2

Networking Parameters

This subsection describes the device's networking parameters.

57.2.1 Ethernet Parameters

The Ethernet parameters are described in the table below.
Parameter
Physical Ports Settings Table
Web: Physical Ports
Settings
CLI: configure
voip/physical-port
[PhysicalPortsTable]
Ethernet Group Settings Table
Web: Ethernet Group
Settings
CLI: configure voip/ether-
group
[EtherGroupTable]
Version 6.8
Table 57-9: Ethernet Parameters
This table parameter configures the physical Ethernet ports
The format of this parameter is as follows:
[ PhysicalPortsTable ]
FORMAT PhysicalPortsTable_Index = PhysicalPortsTable_Port,
PhysicalPortsTable_Mode, PhysicalPortsTable_NativeVlan,
PhysicalPortsTable_SpeedDuplex, PhysicalPortsTable_PortDescription,
PhysicalPortsTable_GroupMember, PhysicalPortsTable_GroupStatus;
[ \PhysicalPortsTable ]
For example:
PhysicalPortsTable 0 = GE_4_1, 1, 1, 4, "User Port #0", GROUP_1,
Active;
PhysicalPortsTable 1 = GE_4_2, 1, 1, 4, "User Port #1", GROUP_1,
Redundant;
Note: For a description of this parameter, see Configuring Physical
Ethernet Ports on page 117.
Defines the transmit (Tx) and receive (Rx) settings for the Ethernet port
groups. The format of this parameter is as follows:
[EtherGroupTable]
FORMAT EtherGroupTable_Index = EtherGroupTable_Group,
EtherGroupTable_Mode, EtherGroupTable_Member1,
EtherGroupTable_Member2;
[\EtherGroupTable]
For a description of this parameter, see Configuring Ethernet Port
Groups on page 119.
Note: For this parameter to take effect, a device reset is required.
799
57. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC