Table of Contents
Advertisement
3.
Once the bottom is clear of the DIN rail, lift the device straight up to unhook it
from the DIN rail.
\
2.3.2
Wall-Mounting
The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
Note!
When installing, make sure to allow for enough space to properly install
the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail
plate.
1.
Rotate the device to the rear side and locate the DIN mounting plate.
2.
Remove the screws securing the DIN mounting plate to the rear panel of the
switch.
3.
Remove the DIN mounting plate. Store the DIN mounting plate and provided
screws for later use.
4.
Align the wall mounting plates on the rear side. The screw holes on the device
and the mounting plates must be aligned, see the following illustration.
EKI-7710 Series User Manual
Figure 2.2 Removing the DIN-Rail
13
1
DIN Rail
2
Advertisement
Table of Contents
