Figure 4.17 L2 Switching > Link Aggregation > Load Balance; Figure 4.18 L2 Switching > Link Aggregation > Lag Management - Advantech EKI-7710E-2C User Manual

To access this page, click L2 Switching > Link Aggregation > Load Balance.
Figure 4.17 L2 Switching > Link Aggregation > Load Balance
The following table describes the items in the previous figure.
Item
Load Balance Algo-
rithm
Apply
The ensuing table for Load Balance Information settings are informational only:
Load Balance Algorithm.
4.5.3.2 LAG Management
Link aggregation is also known as trunking. It is a feature available on the Ethernet
gateway and is used with Layer 2 Bridging. Link aggregation allows for the logical
merging of multiple ports into a single link.
To access this page, click L2 Switching > Link Aggregation > LAG Management.
Figure 4.18 L2 Switching > Link Aggregation > LAG Management
The following table describes the items in the previous figure.
Item
LAG
Name
Type
Ports
Apply
The ensuing table for LAG Management Information settings are informational
only: LAG, Name, Type, Link State, Active Member, Standby Member, Edit (click to
modify the settings) and Clear (click to load default settings).
4.5.3.3 LAG Port Settings
The LAG Port Settings page allows you to enable or disable, set LAG status, speed
and flow control functions.
In this example we will configure a LAG between the following switches:
EKI-7710 Series User Manual
Description
Select the radio button to select the Load Balance Setting: MAC
Address or IP/MAC Address.
Click Apply to save the values and update the screen.
Description
Click the drop-down menu to select the designated trunk group:
Trunk 1 ~8.
Enter an entry to specify the LAG name.
Click the radio button to specify the type mode: Static or LACP.
Click the drop-down menu to select designated ports: Port1-10.
Click Apply to save the values and update the screen.
47