Q Vlan; Figure 4.21 L2 Switching > Link Aggregation > Lacp Port Settings - Advantech EKI-7710E-2C User Manual

To access this page, click L2 Switching > Link Aggregation > LACP Port Settings.
Figure 4.21 L2 Switching > Link Aggregation > LACP Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Priority
Timeout
Mode
Apply
The ensuing table for LACP Port Information settings are informational only: Port
Name, Priority, Timeout and Mode.
4.5.4

802.1Q VLAN

The 802.1Q VLAN feature allows for a single VLAN to support multiple VLANs. With
the 802.1Q feature you can preserve VLAN IDs and segregate different VLAN traffic.
The 802.1Q VLAN tag feature encapsulates the 802.1Q VLAN tagging within another
802.1Q VLAN tag. The outer tag is assigned following the AP group, while the inner
VLAN ID is assigned dynamically by the AAA server.
4.5.4.1 VLAN Management
The management of VLANs is available through the VLAN Settings page. Through
this page you can add or delete VLAN listings and add a prefix name to an added
entry.
EKI-7710 Series User Manual
Description
Select a port for the LACP Port Settings. The listed available settings
are: Port1-10.
However, the available settings are dependent on the connected
LACP device and may not be listed as displayed in the current figure.
Enter a variable (1 to 65535) to assign a priority to the defined port
selection.
Click the radio button to select a long or short timeout period.
Click the radio button to select the setting mode: Active or Passive.
Active: Enables LACP unconditionally.

Passive: Enables LACP only when an LACP device is detected

(default state).
Click Apply to save the values and update the screen.
49