Reverse-Route Preference - HP MSR Series Command Reference Manual

# Display the routing table. You can see a created static route. (Other information is not shown.)
[Sysname] display ip routing-table
...
Destination/Mask
3.0.0.0/24
Related commands
display ip routing-table (Layer 3—IP Routing Command Reference)
•
ipsec policy
•
ipsec policy-template
•

reverse-route preference

Use reverse-route preference to change the preference of the static routes created by IPsec RRI.
Use undo reverse-route preference to restore the default.
Syntax
reverse-route preference number
undo reverse-route preference
Default
The preference for the static routes created by IPsec RRI is 60.
Views
IPsec policy view, IPsec policy template view
Predefined user roles
network-admin
Parameters
number: Sets a preference value. The value range is 1 to 255. A smaller value represents a higher
preference.
Usage guidelines
When you change this preference in an IPsec policy, the device deletes all IPsec SAs created according
to this IPsec policy, and the associated static routes.
Examples
# Change the preference to 100 for static routes created by IPsec RRI.
<Sysname> system-view
[Sysname] ipsec policy 1 1 isakmp
[Sysname-ipsec-policy-isakmp-1-1] reverse-route preference 100
Related commands
• ipsec policy
ipsec policy-template
•
Proto Pre Cost
Static 60 0
339
NextHop Interface
1.1.1.2 GigabitEthernet2/1/1