Portal Commands; Display Portal Interface - HP MSR Series Command Reference Manual

Portal commands

display portal interface

Use display portal interface to display portal configuration and portal running state on an interface.
Syntax
display portal interface interface-type interface-number
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Examples
# Display portal configuration and portal running state on interface GigabitEthernet 2/1/1.
<Sysname> display portal interface gigabitethernet 2/1/1
Portal information of GigabitEthernet2/1/1
IPv4:
Portal status: Enabled
Authentication type: Layer3
Portal Web server:wbs
Authentication domain: my-domain
BAS-IP: Not configured
User detection: Type: ICMP
Action for server detection:
Server type
Web server
Portal server
Layer3 source network:
IP address
1.1.1.1
Destination authentication subnet:
IP address
2.2.2.2
IPv6:
Portal status: enabled
Authentication type: layer3
Portal Web server:wbsv6
Interval: 300s
Server name
wbs
pts
Mask
255.255.0.0
Mask
255.255.255.0
150
Attempts: 5 Idle time: 180s
Action
fail-permit
fail-permit