Arp Gateway Protection Commands; Arp Filter Source - HP MSR Series Command Reference Manual

Layer 3 aggregate interface/subinterface view
VLAN interface view
Predefined user roles
network-admin
Parameters
start-ip-address: Specifies the start IP address of the scanning range.
end-ip-address: Specifies the end IP address of the scanning range. The end IP address must be higher
than or equal to the start IP address.
Usage guidelines
ARP scanning automatically creates ARP entries for devices in the specified address range. IP addresses
already in existing ARP entries are not scanned.
If the interface's primary and secondary IP addresses are in the address range, the sender IP address in
the ARP request is the address on the smallest network segment.
If no address range is specified, the device learns ARP entries for devices on the subnet where the
primary IP address of the interface resides. The sender IP address in the ARP requests is the primary IP
address of the interface.
The start and end IP addresses must be on the same subnet as the primary IP address or secondary IP
addresses of the interface.
ARP scanning will take some time. To stop an ongoing scan, press Ctrl + C. Dynamic ARP entries are
created based on ARP replies received before the scan is terminated.
Examples
# Configure the device to scan neighbors on the network where the primary IP address of
GigabitEthernet 2/1/1 resides.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] arp scan
# Configure the device to scan neighbors in an address range.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/11
[Sysname-GigabitEthernet2/1/1] arp scan 1.1.1.1 to 1.1.1.20

ARP gateway protection commands

This feature is available on only the routers installed with Layer 2 LAN switching interface modules.

arp filter source

Use arp filter source to enable ARP gateway protection for a gateway.
Use undo arp filter source to disable ARP gateway protection for a gateway.
Syntax
arp filter source ip-address
535