Portal Web-Server - HP MSR Series Command Reference Manual

If the device receives a reply, it stops sending detection packets. Then the device restarts the idle
•
timer and waits for the packets from the user.
Direct authentication and re-DHCP authentication support both ARP detection and ICMP detection.
Cross-subnet authentication only supports ICMP detection.
If firewall policies on the access device filter out ICMP packets, ICMP detection might fail and result in the
logout of portal users. Make sure the access device does not block ICMP packets before you enable
ICMP detection on an interface.
Examples
# Enable online detection of IPv4 portal users on interface GigabitEthernet 2/1/1. Configure the
detection type as ICMP, the maximum number of detection attempts as 5, the detection interval as 10
seconds, and the user idle timeout as 300 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname–GigabitEthernet2/1/1] portal user-detect type icmp retry 5 interval 10 idle 300
Related commands
display portal interface

portal web-server

Use portal web-server to create a portal Web server and enter its view.
Use undo portal web-server to delete the specified portal Web server.
Syntax
portal web-server server-name
undo portal web-server server-name
Default
No portal Web server is configured on the device.
Views
System view
Predefined user roles
network-admin
Parameters
server-name: Specifies a portal Web server by its name, a case-sensitive string of 1 to 32 characters.
Usage guidelines
The portal Web server pushes portal authentication pages to portal users during authentication. The
access device redirects HTTP requests of unauthenticated portal users to the portal Web server. In portal
Web server view, you can configure the URL and URL parameters for the portal Web server and the
portal Web server detection function.
Examples
# Create portal Web server wbs and enter its view.
<Sysname> system-view
[Sysname] portal web-server wbs
181