TG-PEM Wiring Diagram
(zone connections not shown)
•
The connection from
Telguard Power on the
TG-PEM to the DC
connection on the TG-7
or TG-7FS should be the
ONLY power supply
connection. The AC
power and battery
connectors must NOT
be used. LED8 (AC
Power) should not be
lit.
•
Supervised zones utilize
2.2kΩ EOL resistors (not
provided).
STEP-BY-STEP:
1. Register the TG-7 or TG-7FS
Use the dealer portal at www.telguard.com.
2. Pre-configure the TG-PEM prior to installation
Use the Power Expansion Module tab for the device registered.
3. Mount the TG-7 or TG-7FS
Complete all steps of the physical installation as outlined in the
TG-7 series manual. Do not activate yet.
4. Mount the TG-PEM
Tip: To ease mounting of TG-PEM board, pre-thread the metal bracket
using the provided mounting screws (marked in red in diagram)
•
Remove top left mounting screw that holds the TG-7
series board (indicated by arrow).
•
Orient bracket as shown in diagram.
Quick Install Guide
Installing the TG-PEM inside the TG-7 or TG-7FS is simple, but watching our installation
video will get you going in no time and insure your installation is quick and easy.
Scan the QR code or visit
telguard.com/pem
including the full Installation Manual.
Alarm Panel
Burglary Systems: STC1 needs to
be connected to a 24-hour panel
input zone to indicate alarm
conditions from TG-PEM. STC2
could be used to indicate TG-7
trouble conditions.
for the installation video and other useful resources
TG-PEM
Panel Power (DC)
Fire Systems: STC1
needs to be connected
to a panel input zone
to indicate all trouble
Power from TG-PEM
conditions.
•
Insert bracket at an angle so that top mounting point
slides under board as depicted, and angled tab
threads through the enclosure bump out.
•
Replace screw to securely mount bracket and board.
Pre-thread using screws
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED8
TG-7FS
LTE
DC
STC2 STC1 TRIP
BATT
AC
Do Not Use these power
connectors when using TG-PEM.
LED1
LED2
LED3
LED4
LED5
LED6
LED7
LED8
TG-7FS
LTE
```
DC
STC2 STC1 TRIP
BATT
AC