Removing And Installing Steering Angle Sender; Removing And Installing Brake Servo Vacuum Sender - Volkswagen Passat 2011 Workshop Manual

– Pull connector -1- off ESP sensor unit - G419- .
– Remove the three securing nuts -arrows-.
– Remove ESP sensor unit - G419- .
Installing:
– Install in reverse order.
When installing the ESP sensor unit - G419- , make sure it is cor‐
rectly seated in its bracket and is free of stress.
Note
Do not use the securing nuts to forcibly position ESP sensor unit
- G419- .
– Tighten securing nuts to 9 Nm.
– Code control unit -J104- with ⇒ Vehicle diagnostic tester in
"Guided fault finding".
To do this, carry out basic setting of steering angle sender - G85- ,
lateral acceleration sender - G200- , brake pressure sender -
G201- and longitudinal acceleration sender - G251- .
– Carry out basic setting of "brake system" (electromechanical
parking brake).
Connecting ⇒ Vehicle diagnostic tester and selecting functions
⇒ page 8 .
4.6 Removing and installing steering angle
sender
The steering angle sender - G85- is located between the steering
wheel and steering column switch.
Removing and installing:
⇒ Electrical system; Rep. gr. 94 ; Steering column switch module;
Assembly overview - steering column switch module .
– Then perform basic setting of steering angle sender - G85- .
Connecting ⇒ Vehicle diagnostic tester and selecting functions
⇒ page 8 .
4.7 Removing and installing brake servo
vacuum sender
Removing:
– Remove battery ⇒ Electrical system; Rep. gr. 27 ; Battery;
Removing and installing battery .
The battery is installed in the luggage compartment on vehicles
with a 6-cylinder petrol engine and therefore only the air filter
housing must be removed.
– Remove battery tray.
Passat 2011 ➤ , Passat Variant 2011 ➤
Brake systems - Edition 02.2014
33
4. Sensors