Tektronix AFG2021 Programmer's Manual page 95

Examples
[SOURce[1]]:VOLTage:UNIT
Group
Syntax
Related Commands
Arguments
Returns
Examples
*SRE
AFG2021 Arbitrary Function Generator Programmer Manual
SOURce1:VOLTage:LIMit:LOW 10mV
sets the lower limit of CH 1 output amplitude to 10 mV.
This command sets or queries the units of output amplitude for the specified
channel. This command does not affect the offset, High level, or Low level
of output. The setting of this command is not affected by the units setting of
[SOURce[1]]:VOLTage[:LEVel][:IMMediate][:AMPLitude] command.
Source
[SOURce[1]]:VOLTage:UNIT
[SOURce[1]]:VOLTage:UNIT?
[SOURce[1]]:VOLTage[:LEVel][:IMMediate][:AMPLitude]
VPP sets the units of the output voltage to Vp-p.
VRMS sets the units of the output voltage to Vrms.
DBM sets the units of the output voltage to dBm. You cannot specify DBM if
the load impedance is set to infinite.
VPP|VRMS|DBM
SOURce1:VOLTage:UNIT VPP
sets the voltage units to Vp-p.
This command sets and queries the bits in the Service Request Enable Register
(SRER).
{VPP|VRMS|DBM}
Command Descriptions
2-77