Tektronix AFG2021 Programmer's Manual page 67

Returns
Examples
[SOURce[1]]:FREQuency:MODE
Group
Syntax
Related Commands
Arguments
Returns
Examples
AFG2021 Arbitrary Function Generator Programmer Manual
<units>::=[Hz | kHz | MHz]
<frequency>
SOURce1:FREQuency:FIXed 500kHz
sets the CH 1 output frequency to 500 kHz when the Run Mode is set to other
than Sweep.
This command sets or queries the frequency sweep state. You can select sine,
square, ramp, or arbitrary waveform for sweep. The instrument automatically
changes to the Continuous mode if any waveform is selected other than sine,
square, ramp, or an arbitrary waveform.
Source
[SOURce[1]]:FREQuency:MODE
[SOURce[1]]:FREQuency:MODE?
[SOURce[1]]:FREQuency[:CW|:FIXed], [SOURce[1]]:FREQuency:CENTer,
[SOURce[1]]:FREQuency:SPAN, [SOURce[1]]:FREQuency:STARt,
[SOURce[1]]:FREQuency:STOP
CW|FIXed means that the frequency is controlled by the
[SOURce[1]]:FREQuency[:CW|:FIXed] command. The sweep is
invalid.
SWEep means that the output frequency is controlled by the sweep command
set. The sweep is valid.
CW|FIXed|SWEep
SOURce1:FREQuency:MODE SWEep
controlling the CH 1 output frequency.
Command Descriptions
{CW|FIXed|SWEep}
specifies the sweep command set for
2-49