Configuring Threshold Monitoring - HP A3100-8 v2 EI Configuration Manual

To do...
Configure the source IP address of
probe packets
Configure optional parameters

Configuring threshold monitoring

Configuration prerequisites
Before you configure threshold monitoring, complete the following tasks:
• Configure the destination address of the trap message by using the snmp-agent target-host
command. For more information about the snmp-agent target-host command, see the Network
Management and Monitoring Command Reference.
Create an NQA test group and configure the related parameters.
•
Configuring threshold monitoring
Follow these steps to configure threshold monitoring:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Configure to send traps to the
network management server under
specified conditions
Configure a reaction entry for
monitoring the probe duration of a
test (not supported in UDP jitter and
voice tests)
Configure a reaction entry for
monitoring the probe failure times
(not supported in UDP jitter and
voice tests)
Use the command...
source ip ip-address
See "Configuring optional
parameters for an NQA test
group"
Use the command...
system-view
nqa entry admin-name operation-tag
type { dhcp | dlsw | dns | ftp | http | icmp-echo
| snmp | tcp | udp-echo | udp-jitter | voice }
reaction trap { probe-failure
consecutive-probe-failures | test-complete |
test-failure cumulate-probe-failures }
reaction item-number checked-element
probe-duration threshold-type { accumulate
accumulate-occurrences | average | consecutive
consecutive-occurrences } threshold-value
upper-threshold lower-threshold [ action-type
{ none | trap-only } ]
reaction item-number checked-element probe-fail
threshold-type { accumulate
accumulate-occurrences | consecutive
consecutive-occurrences } [ action-type { none |
trap-only } ]
25
Remarks
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Optional
Remarks
—
—
—
Required
Configure to send
traps.
No traps are sent to
the network
management server
by default.