Configuring And Enabling Call-Home Features; Configuring And Enabling Ethernet Events; Configuring Threshold Alerts - HP StorageWorks Director 2/140 Installation Manual

Hide thumbs Also See for StorageWorks Director 2/140:
Table of Contents

Advertisement

13.Click Send Test E-mail.
A test message is sent to configured e-mail recipients.
14.Click OK to save the information and close the Email Event Notification Setup dialog box.
15.Maximize the Hardware View (Element Manager).
16.At the Hardware View, select Maintenance > Enable E-Mail Notification.
A check appears in the box to indicate e-mail notification for the director is enabled, and the
menu closes.
NOTE:
Use HAFM to enable or disable e-mail event notification for each director.

Configuring and enabling call-home features

There are two call-home features available, and one is installed with the HAFM application. To
learn more about configuring call-home features, refer to the HP StorageWorks HA-Fabric Manager
appliance installation guide.

Configuring and enabling Ethernet events

Perform this procedure to configure and enable Ethernet events. An Ethernet event is recorded (after
a user-specified time interval) when the director-to-HAFM appliance communication link drops. To
configure and enable Ethernet events:
1.
Select Monitor > Ethernet Event.
The Configure Ethernet Event dialog box appears
Figure 35
Configure Ethernet Event dialog box
2.
Select the Enable Ethernet Events box.
A check appears in the box to indicate Ethernet events are enabled.
3.
Enter a value between 10 and 120 minutes in the Ethernet Timeout box.
4.
Click OK to close the dialog box.

Configuring threshold alerts

Threshold alerts notify you when the transmit (Tx) or receive (Rx) throughput reaches specified values
for specific director ports or port types (E_Ports or F_Ports). You are notified of a threshold alert as
follows:
A yellow triangle appears on the port in the Port Card View.
A yellow triangle appears on the port in the Hardware View.
A yellow triangle appears in the Alert column of the Port List View.
64
Installing and configuring the director
(Figure
35).

Advertisement

Table of Contents
loading

Table of Contents