Configuring Dlsw Tests - HP A3100-8 v2 EI Configuration Manual

To do...
Configure the size of the data field
in each probe packet
Configure the string to be filled in
the data field of each probe packet
Configure the number of probe
packets to be sent during each
voice probe operation
Configure the interval for sending
probe packets during each voice
probe operation
Configure the interval the NQA
client must wait for a response from
the server before it regards the
response times out
Configure optional parameters
NOTE:
Only one probe operation is performed in one voice test.

Configuring DLSw tests

DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring a DLSw test
Follow these steps to configure DLSw tests:
To do...
Enter system view
Enter NQA test group view
Configure the test type as DLSw,
and enter test type view
Configure the destination address
of probe packets
Use the command...
data-size size
data-fill string
probe packet-number
packet-number
probe packet-interval
packet-interval
probe packet-timeout
packet-timeout
See "Configuring optional
parameters for an NQA test
group"
Use the command...
system-view
nqa entry admin-name
operation-tag
type dlsw
destination ip ip-address
24
Remarks
Optional
By default, the probe packet size
depends on the codec type. The
default packet size is 172 bytes for
G.711A-law and G.711 μ-law
codec type, and 32 bytes for
G.729 A-law codec type.
Optional
By default, the string is the
hexadecimal number
00010203040506070809.
Optional
1000 by default.
Optional
20 milliseconds by default.
Optional
5000 milliseconds by default.
Optional
Remarks
—
—
Required
Required
By default, no destination IP
address is configured.