Configuring Mirroring Ports For The Local Mirroring Group; Configuring Mirroring Cpus For The Local Mirroring Group - HP A3100-8 v2 EI Configuration Manual

To do...
Enter system view
Create a local mirroring group
NOTE:
A local mirroring group takes effect only after you configure a monitor port and mirroring ports/CPUs for
it.

Configuring mirroring ports for the local mirroring group

If you use system view, you can use a list to configure multiple mirroring ports for a mirroring group at one
time. If you use interface view, you assign only the current port to the group as a mirroring port, so you
must repeat the step for each additional port.
Configuring mirroring ports in system view
Follow these steps to configure mirroring ports for a local mirroring group in system view:
To do...
Enter system view
Configure mirroring ports
Configuring a mirroring port in interface view
Follow these steps to configure a mirroring port for a local mirroring group in interface view:
To do...
Enter system view
Enter interface view
Configure the current port as a
mirroring port
NOTE:
A mirroring group can contain multiple mirroring ports.

Configuring mirroring CPUs for the local mirroring group

Follow these steps to configure mirroring CPUs for a local mirroring group:
To do...
Enter system view
Use the command...
system-view
mirroring-group group-id local
Use the command...
system-view
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
Use the command...
system-view
interface interface-type
interface-number
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Use the command...
system-view
129
Remarks
—
Required
Remarks
—
Required
By default, no mirroring port is
configured for a mirroring group.
Remarks
—
—
Required
By default, a port does not serve as
a mirroring port for any mirroring
group.
Remarks
—