Configuring Udp Jitter Tests - HP A3100-8 v2 EI Configuration Manual

To do...
Enter system view
Enter NQA test group view
Configure the test type as HTTP,
and enter test type view
Configure the IP address of the
HTTP server as the destination
address of HTTP request packets
Configure the source IP address of
request packets
Configure the operation type
Configure the website that an HTTP
test visits
Configure the HTTP version used in
HTTP tests
Configure optional parameters
NOTE:
The TCP port must be port 80 on the HTTP server for NQA HTTP tests.

Configuring UDP jitter tests

NOTE:
Do not perform NQA UDP jitter tests on known ports, ports from 1 to 1023. Otherwise, UDP jitter tests
might fail or the corresponding services of this port might be unavailable.
Real-time services such as voice and video have high requirements on delay jitters. UDP jitter tests of an
NQA test group obtain uni/bi-directional delay jitters. The test results help you verify whether a network
can carry real-time services.
A UDP jitter test performs the following procedure:
The source sends packets to the destination port at regular intervals.
1.
Use the command...
system-view
nqa entry admin-name
operation-tag
type http
destination ip ip-address
source ip ip-address
operation { get | post }
url url
http-version v1.0
See "Configuring optional
parameters for an NQA test
group"
17
Remarks
—
—
Required
Required
By default, no destination IP
address is configured.
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Optional
By default, the operation type for
the HTTP is get, which means
obtaining data from the HTTP
server.
Required
Optional
By default, HTTP 1.0 is used.
Optional