To do...
Configure the current port as a
mirroring port
NOTE:
A mirroring group can contain multiple mirroring ports.
•
To ensure that the port mirroring function works properly, do not assign a mirroring port to the remote
•
probe VLAN.
Configuring mirroring CPUs for the remote source mirroring group
Follow these steps to configure mirroring CPUs for the remote source mirroring group:
To do...
Enter system view
Configure mirroring CPUs
Configuring the reflector port for the remote source group
You can configure the reflector port for a mirroring group in system view, or assign the current port to it
as the reflector port in interface view. The two configuration modes lead to the same result.
Configuring the reflector port in system view
•
Follow these steps to configure the reflector port for the remote source group in system view:
To do...
Enter system view
Configure the reflector port for the
remote source group
Configuring the reflector port in interface view
•
Follow these steps to configure the reflector port for the remote source group in interface view:
To do...
Enter system view
Enter interface view
Configure the current port as the
reflector port
Use the command...
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Use the command...
system-view
mirroring-group group-id
mirroring-cpu slot slot-number-list
{ both | inbound | outbound }
Use the command...
system-view
mirroring-group group-id
reflector-port reflector-port
Use the command...
system-view
interface interface-type
interface-number
mirroring-group group-id
reflector-port
133
Remarks
Required
By default, a port does not serve as
a mirroring port for any mirroring
group.
Remarks
—
Required
By default, no mirroring CPU is
configured for a mirroring group.
Remarks
—
Required
By default, no reflector port is
configured for a remote source
group.
Remarks
—
—
Required
By default, a port does not serve as
the reflector port for any remote
source group.