Creating A Stack; Configuring Stack Ports Of A Slave Device; Logging In To The Cli Of A Slave From The Master - HP A3100-8 v2 EI Configuration Manual

Creating a stack

After you execute the stack role master command on a stack-capable device, the device becomes the
master device of a stack and automatically adds the devices connected with its stack ports to the stack.
Follow the steps below to create a stack:
To do...
Enter system view
Create a stack
NOTE:
After you configure a device as the master device of a stack, the prompt changes to <stack_0.Sysname>,
where Sysname is the system name of the device.

Configuring stack ports of a slave device

You need to configure stack ports to add a slave device to the stack.
The ports of a slave device that connect to other stack devices need to be configured as stack ports.
Follow the steps below to configure stack ports:
To do...
Enter system view
Configure the specified ports as
stack ports
NOTE:
After a device joins a stack and becomes a slave device of the stack, the prompt changes to
<stack_n.Sysname>, where n is the stack number assigned by the master device, and Sysname is the
system name of the device.

Logging in to the CLI of a slave from the master

In a stack, you can log in to the CLI of a slave device from the master device and perform configurations
for the slave device.
Follow the step below to log in to the CLI of a slave device from the master device:
To do...
Log in to the CLI of the specified
slave device from the master
device
NOTE:
The stack switch-to command is used to log in to the CLI of a slave device from the master with the user
level being unchanged. To return to the master device, use the quit command.
Use the command...
system-view
stack role master
Use the command...
system-view
stack stack-port stack-port-num
port interface-list
Use the command...
stack switch-to member-id
150
Remarks
—
Required
Remarks
—
Required
By default, a port is not a stack
port.
Remarks
Required
Available in user view