Udp Echo Test Configuration Example - HP A3100-8 v2 EI Configuration Manual

[DeviceA] nqa schedule admin test start-time now lifetime forever
# Stop the TCP tests after a period of time.
[DeviceA] undo nqa schedule admin test
# Display the results of the last TCP test.
[DeviceA] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 1
Min/Max/Average round trip time: 13/13/13
Square-Sum of round trip time: 169
Last succeeded probe time: 2007-11-22 10:27:25.1
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of TCP tests.
[DeviceA] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index
1

UDP echo test configuration example

Network requirements
As shown in
Device B. The destination port number is 8000.
Figure 14 Network diagram for the UDP echo tests
Configuration procedure
NOTE:
Before you make the configuration, make sure the devices can reach each other.
Configure Device B.
1.
# Enable the NQA server, and configure a listening service to listen to IP address 10.2.2.2 and UDP port
8000.
Response Status
13 Succeeded
Figure 14, configure NQA UDP echo tests to test the round-trip time between Device A and
Receive response times: 1
Time
2007-11-22 10:27:25.1
42