Download Print this page

HP A3100-8 v2 EI Configuration Manual: Configuring Snmp Tests

A3100 v2 switch series.
Hide thumbs

Advertisement

To do...
Configure the interval the NQA
client must wait for a response from
the server before it regards the
response is timed out
Configure the source IP address for
UDP jitter packets
Configure optional parameters
NOTE:
The probe count command specifies the number of probe operations during one UDP jitter test. The probe
packet-number command specifies the number of probe packets sent in each UDP jitter probe operation.

Configuring SNMP tests

SNMP tests of an NQA test group are used to test the time the NQA client takes to send an SNMP packet
to the SNMP agent and receive a response.
Configuration prerequisites
Before you start SNMP tests, enable the SNMP agent function on the device that serves as an SNMP
agent. For more information abut SNMP agent configuration, see the chapter "SNMP configuration."
Configuring SNMP tests
Follow these steps to configure SNMP tests:
To do...
Enter system view
Enter NQA test group view
Configure the test type as SNMP,
and enter test type view
Configure the destination address
of SNMP packets
Specify the source port of SNMP
packets
Use the command...
probe packet-timeout
packet-timeout
source ip ip-address
See
"Configuring optional
parameters for an NQA test
group"
Use the command...
system-view
nqa entry admin-name
operation-tag
type snmp
destination ip ip-address
source port port-number
19
Remarks
Optional
3000 milliseconds by default.
Optional
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
Optional
Remarks
Required
Required
By default, no destination IP
address is configured.
Optional
By default, no source port number
is specified.

Advertisement

   Also See for HP A3100-8 v2 EI

   Related Manuals for HP A3100-8 v2 EI

Comments to this Manuals

Symbols: 0
Latest comments: