Configuring The Member Switches; Enabling Ndp; Enabling Ntdp; Manually Collecting Topology Information - HP A3100-8 v2 EI Configuration Manual

Rebooting a member switch
To do...
Enter system view
Enter cluster view
Reboot a specified member switch

Configuring the member switches

Enabling NDP

See Enabling NDP globally and for specific

Enabling NTDP

See Enabling NTDP globally and for specific

Manually collecting topology information

See Manually collecting topology

Enabling the cluster function

See Enabling the cluster

Deleting a member switch from a cluster

To do...
Enter system view
Enter cluster view
Delete a member switch from the
cluster
Configuring access between the management
switch and its member switches
After having successfully configured NDP, NTDP and cluster, configure, manage and monitor the
member switches through the management switch. You can manage member switches in a cluster
through switching from the operation interface of the management switch to that of a member switch or
configure the management switch by switching from the operation interface of a member switch to that
of the management switch.
Follow these steps to configure access between member switches of a cluster:
Use the command...
system-view
cluster
reboot member { member-number
| mac-address mac-address }
[ eraseflash ]
ports.
ports.
information.
function.
Use the command...
system-view
cluster
undo administrator-address
117
Remarks
—
—
Required
Remarks
—
—
Required