Download Print this page

HP A3100-8 v2 EI Configuration Manual: Cluster Management Configuration Example

A3100 v2 switch series.
Hide thumbs


Cluster management configuration example

Network requirements
Three switches form cluster abc, whose management VLAN is VLAN 10. In the cluster, Switch B
serves as the management switch (Administrator), whose network management interface is
VLAN-interface 2; Switch A and Switch C are the member switches (Member).
All the devices in the cluster use the same FTP server and TFTP server on host, and
use the same SNMP NMS and log services on host IP address:
Add the device whose MAC address is 000f-e201-0013 to the blacklist.
Figure 44 Network diagram for cluster management configuration
Configuration procedure
Configure the member switch Switch A
# Enable NDP globally and for port Ethernet 1/0/1.
<SwitchA> system-view
[SwitchA] ndp enable
[SwitchA] interface Ethernet 1/0/1
[SwitchA-Ethernet1/0/1] ndp enable
[SwitchA-Ethernet1/0/1] quit
# Enable NTDP globally and for port Ethernet 1/0/1.
[SwitchA] ntdp enable
[SwitchA] interface Ethernet 1/0/1
[SwitchA-Ethernet1/0/1] ntdp enable
[SwitchA-Ethernet1/0/1] quit
# Enable the cluster function.
[SwitchA] cluster enable
Configure the member switch Switch C
As the configurations for the member switches are the same, the configuration procedure for Switch C is


   Also See for HP A3100-8 v2 EI

   Related Manuals for HP A3100-8 v2 EI

Comments to this Manuals

Symbols: 0
Latest comments: