Download Print this page

HP A3100-8 v2 EI Configuration Manual: Configuration Prerequisites; Configuration Procedure; Configuring The Poe Monitoring Function; Configuring Pse Power Monitoring

A3100 v2 switch series.
Hide thumbs

Advertisement

Configuration prerequisites

Enable PoE for PoE interfaces.
Configuration procedure
Follow these steps to configure PoE interface power management:
To do...
Enter system view
Configure PoE interface power
management priority policy
Enter PoE interface view
Configure the power supply
priority for a PoE interface
Configuring the PoE monitoring function
With the PoE monitoring function enabled, the system monitors the parameter values related to PoE
power supply, PSE, PD, and device temperature in real time. When a specific value exceeds the limited
range, the system automatically takes some measures to protect itself.
Configuring PSE power monitoring
When the PSE power exceeds or drops below the specified threshold, the system sends trap messages.
Follow these steps to configure a power alarm threshold for the PSE:
To do...
Enter system view
Configure a power alarm threshold
for the PSE
Monitoring PD
When a PSE starts or ends power supply to a PD, the system sends a trap message.
Configuring PoE interface through PoE profile
You can configure a PoE interface either at the CLI or by using a PoE profile and applying the PoE profile
to the specified PoE interfaces.
To configure a single PoE interface, configure it at the CLI. To configure PoE interfaces in batches, use a
PoE profile.
Use the command...
system-view
poe pd-policy priority
interface interface-type
interface-number
poe priority { critical | high | low }
Use the command...
system-view
poe utilization-threshold
utilization-threshold-value
77
Remarks
Required
Not configured by default.
Optional
low by default.
Remarks
Optional
80% by default.

Advertisement

   Also See for HP A3100-8 v2 EI

   Related Manuals for HP A3100-8 v2 EI

Comments to this Manuals

Symbols: 0
Latest comments: