Figure 33 Ap150 Antenna Connection; Figure 34 Ap150 Connector Panel - Meru Networks AP150 Installation Manual

Installing the Access Points
Antenna
Figure 33: AP150 Antenna Connection
3. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Figure 34: AP150 Connector Panel
Vertical Mounting the AP150
To perform a simple wall mount using the keyholes on the back of the AP150:
1. Remove the attached mounting bracket from the back of the AP150.
2. Mark the location on the wall for two mounting screws. They are placed 4.3"
3. Drill holes at the locations you marked:
—
—
52 Meru Access Point and Radio Switch Installation Guide
Turn clockwise
to tighten
connector, shown in Figure
Antenna 1
Power Ethernet
(reserved)
connection
ANT1
DC 5V
LAN
apart, center-to-center, or one above the other. If you are not using plastic wall
anchors, you must either center the mounting screws on a wall stud or use plastic
wall anchors.
3/16-inch holes if you are using plastic anchors
1/8-inch holes if you are using only the screws
34.
Console
port
Reset Reload
(reserved)
button
RESET RELOAD
CONSOLE
Antenna 2
ANT2
© 2007 Meru Networks, Inc.