Figure 16 Antenna Mounting Arm With Wall Bracket (Shown Attached); Figure 17 Antenna Ceiling Tile Rail Base - Meru Networks AP150 Installation Manual

Installing the RS4000
Antenna attachment
stud (threaded)
Figure 16: Antenna Mounting Arm with Wall Bracket (shown attached)
Figure 17: Antenna Ceiling Tile Rail Base
The RS4000 antenna uses two RF cables (3-foot cables are supplied) to connect to the
SMA connectors on the top panel of the RS4000 (see
be attached to the RS4000 as a result of the procedures described in one of the
previous installation procedures.
Mount the antenna and connect the cables as described in the following:
1. Choose whether to hang the arm on a wall (including solid ceiling wall) or ceiling
—
a. Using the screwholes in the mounting bracket as a template, mark and drill holes
b. Attach the bracket securely with three 1/4" diameter fasteners or one 5/16"
—
a. Pull apart the rail clamps so the ears can fit over the width of the ceiling rail.
b. Squeeze the rail clamp to attach to the ceiling rail.
24 Meru Access Point and Radio Switch Installation Guide
tile rail.
For wall or ceiling mount:
into the wall.
diameter and one 1/4" diameter fastener, if mounting to a wall stud (fasteners
are not supplied).
For ceiling tile rail mount:
Angle adjusting lever
Wall bracket base
Figure 8). The RF cables should
© 2007 Meru Networks, Inc.