Checking LED Activity
AP200 Status LEDs
Four status LEDs on the face of the AP200 also light, as shown in
. .
Figure 31: AP200 Status LEDs
The functions of the status LEDs are described in
When the AP200 is first connected to the controller and any time the access point is
rebooted thereafter, the AP initializes with and then is programmed by the
controller. When the AP is first powered up, all LEDs are green. Thereafter, the
Status LED (see
44
Meru Access Point and Radio Switch Installation Guide
Figure
31) color reflects the various operating states
RF2
RF1
STATUS
POWER
Table
7.
Figure
31.
(Table
7).
© 2007 Meru Networks, Inc.