Figure 23 Ap200 Bracket - Meru Networks AP150 Installation Manual

Vertical Mounting
To vertically mount an AP:
1. Using the bracket holes as a template, mark the location on the wall for the two
Wall cable access
Access point mount
Suspended ceiling
cable access
Figure 23: AP200 Bracket
2. Drill holes at the locations you marked:
—
—
3. If you are using plastic anchors, install them in the holes.
4. Screw in the screws most of the way, so that the screw head is about 1/16 of an
5. Mount the bracket on the screws, placing the circular portion of the keyhole
6. Tighten the screws to secure the bracket.
7. Align the AP200 mounting posts over the circular portion of the keyhole mounts,
© 2007 Meru Networks, Inc.
AP bracket mounting screws. They are placed 4 ½ inches apart, center-to-center,
one above the other. If you are not using plastic wall anchors, you must center
the mounting screws on a wall stud. If you do not center the mounting screws on
a wall stud, you must use plastic wall anchors.
3/16-inch holes if you are using plastic anchors
1/8-inch holes if you are using only the screws
inch from the wall.
mounts over the screw heads and sliding the bracket down.
push the AP in and slide the AP down until it engages with the locking detents.
You should hear it snap in place.
Installing the Access Points
Ceiling mount hole
Access point mount
Locking detent
Access point mount
Ceiling mount hole
Installing the AP200 37