Figure 29 Attaching The Mounting Bracket To The Box Hanger - Meru Networks AP150 Installation Manual

Installing the Access Points
4. Attach the U-joint of the clip to the T-bar and snap in place (see
.
Figure 29: Attaching the Mounting Bracket to the Box Hanger
5. Pass the long end clip through the large center hole to the underside of the the
6. Hold the AP200 next to the mounting bracket to estimate the height of the T-bar
7. Adjust the height of the box hanger using the height adjusting screws (see
8. Clip the box hanger T-rail clips to the ceiling rails, making sure they are securely
9. Connect a drop wire to a building structural element and through the hole
10. Connect the posts of the AP200 to the three keyholes of the mounting bracket and
11. For each antenna, loosen the knurled ring at the base of the antenna (see
12. Connect one end of the PoE 100BaseT Ethernet cable to the 100/1000 Ethernet
Caution!
mistakenly be plugged into the Console port.
42 Meru Access Point and Radio Switch Installation Guide
mounting bracket clip and then attach the bracket to the clip using the supplied
screw (see Figure 29
box hanger to provide enough clearance for the external antennas, which should
be pointing down.
Figure 26).
attached.
provided in the bracket mounting clip. The U.S. National Electrical Safety Code
requires this additional support.
slide into the keyhole (see
will hear a click.
Figure 21), point the antenna down, then retighten the ring.
connector, shown in Figure
Be sure to connect the Ethernet cable to the Ethernet port; the cable can
for orientation).
Figure 25), ensuring the locking detent is engaged. You
22.
Figure 29).
© 2007 Meru Networks, Inc.