Meru Networks AP150 Installation Manual page 78

Canada. Industry Canada (IC)
Caution!
Note:
Access Points have been designed to operate with the antennas listed below.
Antennas not included in this list are strictly prohibited for use with these devices.
The required antenna impedance is 50 ohms.
AP Model
AP200
AP200
AP150
AP150
AP150
66 Meru Access Point and Radio Switch Installation Guide
Exposure to Radio Frequency Radiation.
The installer of this radio equipment must ensure that the antenna is
located or pointed such that it does not emit an RF field in excess of
Health Canada limits for the general population; consult Safety Code 6,
obtainable from Health Canada's website http://www.hc-sc.gc.ca/rpb.
Meru Access Points
These devices are restricted to indoor use because they operate in the
5.15 to 5.25 GHz frequency range. Industry Canada requires such products
to be used indoors for the frequency range 5.15 GHz to 5.25 GHz to reduce
the potential for harmful interference to co-channel Mobile Satellite sys-
tems.
High-power radars are allocated as primary users of the 5.25 to 5.35 GHz
and 5.65 to 5.85 GHz bands. These radar stations can cause interference
with or damage to these devices, or both.
Antenna Type
Dual-Band Omni-Directional
SAA04-220050
Dual-Band Omni-Directional
TWX-614XRSXX
Dual-Band Omni-Directional
MMO224580608
Single-Band Omni-Directional
SAA04-050280
Panel
MP24013 XFPTNF
Gain (2.4 GHz) Gain (5 GHz)
2 dBi 3 dBi
4 dBi 5 dBi
8 dBi
6 dBi
8 dBi
13 dBi
© 2007 Meru Networks, Inc.