Hoffman/Nema Enclosure Rs4000 Installation - Meru Networks AP150 Installation Manual

c. Attach the rail mount base to the antenna arm by screwing the base into the
2. Connect the RF antenna wires from the RS4000 to the SMA connectors on the top
3. Attach the top of the antenna to the 1/4-20 threaded stud on the swivel head and
4. For a 180
5. Loosen the angle adjusting lever on the swivel assembly, if necessary, to adjust
6. Position the antenna to maximize the reception and tighten the adjusting lever.

Hoffman/NEMA Enclosure RS4000 Installation

Use the procedures in this section to mount the RS4000 within the Hoffman or NEMA
enclosure. It will be necessary to modify the NEMA enclosure by drilling cable pass-
through holes before installing the RS4000.
Note:
unimpeded air flow through the unit. The option to install the RS4000 within a
Hoffman/NEMA enclosure is left to the customer's discretion, based on site-specific
factors such as protection and accessibility, etc. Installation in the Hoffman
enclosure requires drilling air vents and cable pass-through holes.
Creating Cable Pass-through Holes in the NEMA Enclosure
To create cable pass-through holes in the NEMA enclosure, Meru supplies a template
with markings that coincide with the placement of the Ethernet and antenna cable
locations on the RS4000. Depending on the orientation of the RS4000 installation in
the NEMA enclosure, the template is to be used on the side of the enclosure adjacent
to the RS4000 top panel, where the cables connect.
1. Open the lid of the empty NEMA enclosure to provide unimpeded access to the
2. On the outside of the empty NEMA enclosure, locate the top center of the side
3. Using the pattern on the supplied template, mark the center of the holes and drill
© 2007 Meru Networks, Inc.
arm pole (you may have to unscrew and remove the wall mount base if it is
attached to the arm).
of the antenna, using
tighten against the antenna.
o
directional antenna, position the antenna such that the logo on the top
of the antenna is pointing in the direction where reception is required.
the hanging angle.
The recommended Meru installation is a vertical wall mount, which allows for
enclosure sides.
where the cables will exit.
a 1/2" to 1" hole at each of the three locations specified by the template.
Figure 8 or Figure 15
Installing the RS4000
for orientation.
Installing the RS4000 25