Where To Go From Here; Checking Led Activity; Ethernet Connector Leds; Figure 30 Rj-45 Leds - Meru Networks AP150 Installation Manual

13. Check that the AP200 is operating correctly before replacing the ceiling tile to

Where to Go From Here

Now that the AP200 is installed, go to the Meru System Director Getting Started
Guide for instructions on initializing the controller and connecting the controller and
APs to the Ethernet switch to form the WLAN. Return to this chapter to check the
status of the LEDs once the WLAN is operational.

Checking LED Activity

Access point status LEDs are provided on the Ethernet connector and on the face of
the AP200.

Ethernet Connector LEDs

After the AP200 is connected, the LEDs near the RJ-45 connector should light, as
shown in
Figure 30: RJ-45 LEDs
The green LED on the left blinks if any Ethernet activity is taking place. If there is
no Ethernet activity, the LED is off. The LED on the right is solid green if an Ethernet
link is present. If no Ethernet link is present or connectivity is lost, the LED is off.
© 2007 Meru Networks, Inc.
the ceiling. Verify correct operating using the LEDs, as shown in
Activity.
Figure 30.
Link present
Ethernet activity
Where to Go From Here
Checking LED
Installing the AP200 43